Propellerhead Reason - 4.0 Betriebshandbuch PDF herunterladen (Seite 69)

THE SEQUENCER

D If the device that you wish to automate doesn’t have a sequencer track,

the quickest way to add one is by selecting “Create Track for (name of

device)” from the device context menu ([Ctrl]-click (Mac) or right-click on

the device panel).

This will create a new record enabled sequencer track for the device, without any

automation lanes.

D If the track has note lanes you may want turn off the Record Enable but-

ton for the active note lane (unless you plan to record notes and param-

eter automation simultaneously of course).

If the note lane already has clips recorded on it, a new clip will be created when

you record, that will engulf any previous clips on the note lane that the recording

encompasses. Although nothing will be erased, you may end up with a single clip

instead of several separate clips and the original clips may also be split where you

don’t want them to be split. See picture examples below.

Recording automation with the note lane record enabled.

The track is now ready for automation recording. Note that it is not necessary for the

track to be selected or for the track to have Master Keyboard Input to record automa-

tion. The Automation Record Enable button is completely independent from Master

Keyboard Input.

2. Set up the device parameters as you want them (for the static values as ex-

plained previously).

3. Start recording from the desired position.

4. During recording, adjust the desired parameter(s), from the device panel or

from a MIDI remote control surface.

You can automate any parameter for the device - each parameter you tweak will

automatically generate an automation lane and a clip will be recorded on the cor-

responding lane from the point you changed the parameter.

5. Stop recording.

On the device panel, each automated parameter will have a green frame.

The parameters Feedback and Pan are automated.

In Arrange mode, clips on automation lanes indicate the recorded automation data.

Clips on automation lanes differ from note clips in that they have a cut upper right

edge. Automation lanes only have an “On” button and a “Delete Automation Lane” (X)

button.

If you play back the recorded section again, the parameters will change automatically.

Outside the clip boundaries, the parameters will have their original settings (the static

values they had before you started recording).

Recording more for the same parameter

If you need to redo a section of the recorded automation, or simply record more auto-

mation for a parameter, proceed as follows:

1. Set up and start recording in the same way as described above.

As long as you don’t touch the parameter, its automation data will be played back

normally, and no new clip will be created.

2. At the desired position, adjust the parameter.

As soon as you start changing the parameter value, the Automation Override indi-

cator will light up on the transport panel, and a new clip will be created.

D From this point on, the previously recorded automation will be replaced

with the automation events in the new clip.

Automation recording is different from recording on note lanes where nothing is

erased when you record over previously recorded clips. A new automation clip in-

stead will replace any previous automation clip(s) at the same position for the du-

ration of the recording. Automation clips logically cannot be “overdubbed” as you

cannot have two clips with active automation data for the same parameter simulta-

neously.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 401 402

Kommentare zu diesen Handbüchern

Keine Kommentare

Propellerhead Reason - 4.0 Betriebshandbuch Seite 69

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Propellerhead Reason - 4.0