Propellerhead Reason - 1.0.1 Betriebshandbuch PDF herunterladen (Seite 117)

SUBTRACTOR SYNTHESIZER

115

Pitch Bend and Modulation Wheels

The Pitch Bend wheel is used for “bending” notes, like bending the strings on

a guitar. The Modulation wheel can be used to apply various modulation

while you are playing. Virtually all MIDI keyboards have Pitch Bend and Mod-

ulation controls. Subtractor features not only the settings for how incoming

MIDI Pitch Bend and Modulation wheel messages should affect the sound.

Subtractor also has two functional wheels that could be used to apply real

time modulation and pitch bend should you not have these controllers on

your keyboard, or if you aren’t using a keyboard at all. The Subtractor wheels

mirror the movements of the MIDI keyboard controllers.

Pitch Bend Range

The Range parameter sets the amount of pitch bend when the wheel is

turned fully up or down. The maximum range is “24” (=up/down 2 Octaves).

Modulation Wheel

The Modulation wheel can be set to simultaneously control a number of pa-

rameters. You can set positive or negative values, just like in the Velocity

Control section. The following parameters can be affected by the modulation

wheel:

Legato

Legato works best with monophonic sounds. Set Polyphony (see below) to 1

and try the following:

➜ Hold down a key and then press another key without releasing the

previous.

Notice that the pitch changes, but the envelopes do not start over. That

is, there will be no new “attack”.

➜ If polyphony is set to more voices than 1, Legato will only be ap-

plied when all the assigned voices are “used up”.

For example, if you had a polyphony setting of “4” and you held down a 4

note chord, the next note you played would be Legato. Note, however,

that this Legato voice will “steal” one of the voices in the 4 note chord, as

all the assigned voices were already used up!

Parameter

Description

F. Freq This sets modulation wheel control of the Filter 1 Frequency

parameter. A positive value will increase the frequency if the

wheel is pushed forward. Negative values invert this relation-

ship.

F. Res This sets modulation wheel control of the Filter 1 Resonance

parameter. A positive value will increase the resonance if the

wheel is pushed forward. Negative values invert this relation-

ship.

LFO 1 This sets modulation wheel control of the LFO 1 Amount pa-

rameter. A positive value will increase the Amount if the

wheel is pushed forward. Negative values invert this relation-

ship.

Phase This sets modulation wheel control of the Phase Offset pa-

rameter for both Osc 1 and 2. Note that Phase Offset Modu-

lation (Subtraction or Multiplication) must be activated for

this to have any effect (see page 103).

FM This sets modulation wheel control of the FM Amount pa-

rameter. A positive value will increase the FM amount if the

wheel is pushed forward. Negative values invert this relation-

ship. Both oscillators must be activated for this to have any

effect.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 206 207

Kommentare zu diesen Handbüchern

Keine Kommentare

Propellerhead Reason - 1.0.1 Betriebshandbuch Seite 117

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Propellerhead Reason - 1.0.1